Installing a water heater is not a task that should be taken lightly. You may think that you can just plunk down the money and have your hot water heater installed by a handy homeowner or a heating contractor, but you may be surprised at the cost. You need to know what your options are and how much they cost before you even begin. Find out what you need to know about heating contractors, homeowners and more before you get started.
In some states, you don’t need a permit to install a water heater. This means that you can install the heater on your own as long as you follow the instructions carefully. This type of heater does not heat the water directly; rather it heats the water that runs through the unit. So, while it may be easier to install, in the long run, it’s going to be more expensive to use and more wasteful because of the amount of energy it requires.
When you are considering installation, you want to take into account all of your options. For instance, do you want one, two or three-phase heaters? Do you want an open or closed loop? Are you planning on installing it over existing flooring? All of these decisions should be addressed and analyzed before you make any final decisions. While you may want to save money by doing it yourself, it may end up costing you more in the long run if you make a mistake and install the heater incorrectly.
Before you decide what type of system you would like to install, you need to determine the size of the water tank and how many gallons it holds. You’ll also want to determine the number of thermostats required for the system. Depending on where you live, you may need to have a permit in order to install the unit as well.
For businesses, it is important to obtain a permit before installing a water heater. Generally, having a professional install it is the best way. A quick permit is required for the installation or replacement of a water heater. This way it can be properly installed and that it does not create a hazard to the building occupants. You can locate a plumber in Melbourne to help with proper installation.
Some homeowner’s association fees may be required when installing a new water heater. If the system requires more than one heater, then you may have to pay for each additional one. In addition, if your system is located outside, you’ll probably have to get a permit as well for the outdoor unit. Finally, some areas require that you install a back-up heating element in case your main heater stops working. This can be very costly, so it’s always best to double check with the local authorities.
Before you start your search for a water heater, make a list of all the pros and cons. Consider the cost, size and energy efficient of the different units. Think about whether you want to have control over how the water comes out of the heater. You might want to install a system that is
high tech and automatically dispenses hot water when the right temperature is achieved. It might also be worth spending a little extra to have a system that provides a constant flow of water even if your main water heater is not functioning properly.
Once you’ve made your decision on what type of heater you need a permit to install a water heater in your house, you’ll want to find a local contractor who is licensed and able to get the job done. You might want to check out companies in your area by searching the Internet, especially if you are handy enough to install the heater yourself. When shopping around for a company to install your heater, you will want to ask for a written estimate. When you receive the total estimate, it will give you an idea of the total expenses you will be faced with.
You will also have to consider any environmental factors that could affect your home’s water supply. Your heater should be placed as far from any sources of pollutants as possible, such as
gas and oil fields. If your current water source is contaminated, you should consider replacing the entire system with a clean, fresh supply. There are various options available to meet your needs.